Landoll SSB-8, Operator'S Manual

Page: 41 / 90

ASSEMBLY INSTRUCTIONS
2-19
Seed Shaft Sensor Kit - Small
Seedbox
Remove the four 10-24 x 3/4” Self Tapping Screws from
the Magnet Wheel Assembly. Position the rounded half of
the Magnet Wheel Assembly on the seed shaft. Ensure it
fits squarely onto shaft. Mount magnet half to the
rounded half. Ensure it fits squarely onto shaft. Fasten
the two halves together using four #10-24 x 3/4” Self
Tapping Screws.
Do not over tighten .
Identify the seed cups on either side of the Magnet
Wheel Assembly and remove the 1/4-20 hardware. Insert
Sensor into Shaft Sensor Bracket slot.
Note: 8 and 10
foot seeders use Sensor Bracket with 8-1/2” spacin g.
Insert a 1/4-20 x 3/4” Machine Screw into each seed cup.
Align the Shaft Sensor Bracket with the two 1/4-20 x 3/4”
Screws. Secure with existing Lock Washers and Nuts.
Slide/Position Seed Shaft Sensor so it is 1/8” from the
magnet.
See Figure 2-24. Tighten both Retaining Nuts.
Figure 2-20: Small Box Senor Brackets
Seed Shaft
Magnet Wheel
Assembly
3/8 Sq Shaft
Screw,Self Tapping
#10-24 x 3/4
Shaft Sensor
Bracket
Seed Shaft
Sensor
Machine Screw,
1/4-20 x 3/4
Sensor Bracket
8-1/2" Spacing
Screw, Self Tapping
#10-24 x 3/4
Seed Shaft
Magnet Wheel
Assembly
3/8 Sq Shaft
Machine Screw
Existing
Lock Washer, 1/4
Existing
Nut, 1/4-20
,
1/4-20 x 3/4
Shaft Sensor
Bracket
Seed Shaft
Sensor
Sensor Bracket
8-1/2" Spacing
Existing
Lock Washer, 1/4
Existing
Nut, 1/4-20
Retaining Nut
Retaining Nut