TIRES, BRAKES AND DRIVETRAIN
2-15
NOTE
This is best done while gearbox is still on the bench.
NOTICE
13. Reassemble in reverse order and torque bolts to
specifications on page 1-10 and 1-11.
Figure 2-13 Gear Box Cover Removal
Traction Drive Motor Service
1.
Repeat steps 1-4, 6, 7, and 9 in “Gearbox
Replacement” on page 2-14.
2.
Reassemble in reverse order.
NOTICE
Accelerator Pedal
NOTE
The accelerator assembly consists of the potentiometer,
harness, and accelerator pedal.
Adjusting Accelerator Pedal
1.
Set the key switch to OFF, remove the key from the
key switch and put it in a secure area.
2.
Apply the parking brake, perform a Lock Out/Tag Out
procedure, disconnect the battery and block all
wheels.
3.
Remove the floor plates. See “Floor Plate Removal”,
on page 2-1.
NOTE
It is recommended to hold the right hand floor plate in a
vice while doing this procedure.
4.
Loosen the allen head fastener on the pedal arm so
that it can rotate freely. Rotate the pedal until the
pedal touches the rear of the slot. Tighten the
fastener.
5.
Install floor plate assembly back on the forklift.
6.
Install left hand floor plate.
7.
Refer to Landoll Setup Procedure, located in
“Calibration of Steering and Throttle Pot” starting on
page 5-9 to re-calibrate the accelerator module.
Replacing Accelerator Module
1.
Set the key switch to OFF, remove the key from the
key switch and put it in a secure area.
2.
Apply the parking brake, perform a Lock Out/Tag Out
procedure, disconnect the battery and block all
wheels.
3.
Remove the floor plates. See “Floor Plate Removal”,
on page 2-1.
4.
Remove the two round head screws (5/16-18 x 1)
and hardware securing the accelerator to the floor
panel. See Figure 2-1.
5.
Disassemble the accelerator from the floor plate and
install the replacement accelerator in its place.
6.
Loosen the allen headed fastener on the pedal arm
and orient the pedal 90º up. Insert the flat part of the
arm through the slot, rotate and mate the accelerator
mounting surface to the underside of the floor plate.
Align with the 5/16” bolts and tighten to secure the
accelerator.
7.
Adjust the pedal. See “Adjusting Accelerator Pedal”
on page 2-15.
8.
Refer to Landoll Setup Procedure, located in
“Calibration of Steering and Throttle Pot” starting on
page 5-9 to re-calibrate the accelerator module.
The splines of the drive motor and gearbox take a
special grease. See “Lubrication Specifications”
onpage 1-12.
The splines of the drive motor and gearbox take a
special grease. See “Lubrication Specifications”
on page 1-10.
https://www.forkliftpdfmanuals.com/
