F-1108-0121
4-9
Clamp End Spacers - Optional
The Clamp End Spacer Kits are used to eliminate space
between the Axle Clamp and the Wheel Stop.
IMPORTANT
Unfold and lower machine prior to performing any
steps.
Kit Part Number 201442 - 3/4" Axle Spacer
Kit Part Number 201443 - 1/2" Axle Spacer
Installation is the same for either kit.
1. Place the two Axle Spacers between the Axle Clamp
and the Wheel Stop.
2. Insert two 3/8-16 x 1-3/4 Bolts through the Axle
Spacers and secure with 3/8-16 Locknuts.
Refer to the Torque Table for proper bolt torque values.
Note the different torque requirement for Bolts with
Locknut.
Figure 4-7: Clamp End Spacer Kit, 1 of 2 - Optional
201442-201443 ClampEndSpacerK
Axle Spacer
Bolt,
3/8-16 x 1-3/4
Locknut,
3/8-16
Axle Spacer
Locknut,
3/8-16
Axle Spacer
Bolt,
3/8-16 x 1-3/4
Axle Spacer
Axle
Clamp
Wheel Stop
Summary of Contents for Brillion WFPC23
