![background image](http://html2.mh-extra.com/html/landoll/bendi-b40i4/bendi-b40i4_maintenance-manual_3515299077.webp)
TROUBLESHOOTING AND CORRECTIVE MAINTENANCE
3-29
6.
Close the steering column by reversing the steps
outlined in section
“Remove Right Side Cover,” on
this page.
Figure 3-18: Key Switch
Option Rocker (On/Off) Switches
Optional rocker switches are also used to control various
light packages, or other accessories. When an option is
installed, the switch is activated.
1.
Repeat
preceding section “Remove Right Side
Cover,” beginning on this page.
2.
Reach inside the steering column and disconnect the
appropriate accessory switch connector from the
main wire harness.
3. The accessory on/off rocker switches are held by
knurled plastic wings (or tabs). Compress the wings
(or tabs) on one side at a time to release the switch
body, then push it up and out of the slot. See
Figure 3-19
.
NOTE
Be careful when compressing and pushing the switch in
or out. The wings (tabs) could break off if the procedure
is not done evenly on all sides.
4.
Detach the wires from the defective switch, noting the
connection arrangement for installing the new rocker
switch.
5.
Insert the replacement switch in the slot and hold the
wings as necessary to allow it to pop into place.
6.
Connect the cable connector to the wire harness and
close the steering column by reversing the steps
outlined in section “Remove Right Side Cover”.
Figure 3-19: Rocker Switch
Figure 3-20: Steering Column
Steering Column (Console)
NOTE
This is a two man operation, due to weight of steering
column (approximately 30 pounds/66 Kgs.). If an
overhead crane is available, the crane could be strapped
to the steering wheel for support.
1.
Remove the driver’s compartment floor plate. See
"Floor Plate Removal," on page 3-16.
2.
Disconnect the two plugs that connect the dash
harness to the main harness and any optional
lighting harnesses.
3.
Relieve hydraulic pressure in the system by turning
the steering wheel a few times to the left and right.
Summary of Contents for Bendi B40i4
