Landoll 9650FH, Operator'S Manual

Page: 144 / 176

3-46 F-1090-1120
ASSEMBLY INSTRUCTIONS
3 Row Spike and Reel Harrow
Installation
See Figures 2-43 - 2-54 for 3 Row Spike and Reel
Harrow or See Figures 2-55 - 2-66 3RSD & flat reel for
placement dimensions in “Standard Specification”
section.
1. Attach the 3 RSD w/spring and 3 RSD w/o spring
(Models 9650FH-38’-42’ only) arm assemblies to
the rear tube of the center and wing frames using
harrow mounting plates, 3/4-10x5-1/2 hex screws,
clamp bushings and 3/4-10 lock hex nut
See
Figure 3-31 .
2. Harrow arms w/o springs are used as the middle
harrow arm on the inner wings.
NOTE
Location of bar clamps with tabs, and position
harrow arm assemblies in the correct locations.
NOTE
The harrow arms with the catch tray hooks are used on
the outer wings with the catch tray hooks toward the
outside of the machine and the catch trays toward the
center of the machine.
See Figures 2-43 - 2-54 for 3
Row Spike and Reel Harrow or See Figures 2-55 - 2-66
3RSD & flat reel and See Figures 3-31 for proper
placement.
3. Refer to Note: spike bar alignment See Figures 3-31
for proper alignment of spike bar assemblies. Be sure
they are aligned properly on both right and left side of
each section.
4. Attach spike bars to spike harrow arm assemblies
per placement drawings using bar clamps, bar clamp
plates 1/2-13 x 3 hex head cap screws, or bar clamps
w/ tabs, 1/2-13 x 1-1/4 hex head cap screws, and hex
lock nuts.
5. See spring assembly adjustment for initial setting in
“Operating Section”.
6. Attach reel assembly or flat reel assembly to 3 RSD
arm assemblies using 5/8-11 u-bolts and 5/8-11 hex
lock nuts.
7. Attach flat bar reels with angled blades as shown
( See Figure 3-30 )
Figure 3-30: Flat Reel
8. See Figures 2-43 - 2-54 for 3 Row Spike and Reel
Harrow or See Figures 2-55 - 2-66 3RSD & flat reel
placement dimensions of spike harrow arms, spike
bars, and usage of bar clamps or bar clamps w/ tabs.
9. Refer to “3 Row Spike and Reel Adjustments” on
page 4-22 in “Operation and Maintenance” section
for spike angle and spring adjustments.
FRONT