Landoll 9630FH, Operator'S Manual

Page: 48 / 108

3-4 F-1105-1120
ASSEMBLY INSTRUCTIONS
Center Frame Fold and Depth
Control Assembly
IMPORTANT
Read all safety precautions at the front of the section
before attempting any of the following procedures.

WARNING
1. Attach the front & rear fold cylinder mounts to the top
of the center frame using 5/8 x 3-11/16 x 5-1/2
u-bolts and lock nuts
See Figures 3-2 . The
rectangular hole in the front cylinder mount will be
mounted to the left side of the center frame.
2. Attach the DCV valve mount to the front of the fold
cylinder mount with the rectangular hole. Use a
clamp plate on the rear side of the fold cylinder
mount, and fasten with 3/8x2 bolts and lock nuts.
3. Insert a slide pad into the bottom of the hole in the
valve mount.
4. Install a 90 deg elbow in the back side (opposite the
button) of the depth control valve. Fasten the valve
and fitting to the valve mount using 5/16x2-1/4 bolts
and lock nuts.
5. Attach the depth control mount (164205) to the
center lift using 3/8 x 1-1/4 bolts and 3/8 lock nuts.
6. Insert the depth stop tube assembly through the
depth control mount. Attach the rear of the tube
assembly to the depth control mount on the top of the
center lift assembly using a 5/8 x 2-1/2 bolt and lock
nut. Do not over-tighten this bolt as the tube must
pivot freely on the depth control mount.
7.
Using
5/8 x 3-11/16 x 5-1/2
u-bolts and lock nuts,
attach the wing stabilizer to the top of the center
frame.
Do not attempt to lift heavy parts (such as the
frame and rock shaft) manually. Use a hoist or a
fork lift to move these parts into position.