Landoll 330C, Operator'S Manual

Page: 21 / 64

OPERATING INSTRUCTIONS
3-11
Figure 3-5: 20,000# Winch Clutch
b. The 20,000# winch clutch handle has two
positions (See Figure 3-5.) :
c. The HYDRAULIC WINCH CONTROL lever is the
center lever (See Figure 3-2.) It is a three
position control:
Auxiliary Hydraulic Power
Engine Operation
1. The Hydraulic Power Supply Engine is used to power
the hydraulic functions, should the tractor not be
equipped with hydraulic hookups.
IMPORTANT
1. Check the following fluid levels before starting
the engine package: engine oil, fuel supply,
hydraulic oil. (Check oil level while semitrailer is
not tilted as tilting will change the oil level in the
tank.)
2. If the engine does not crank, check the following
on the battery: charge, fluid, terminals, and
cables. Take corrective actions as needed.

CAUTION
2. The Engine Ignition Switch, Choke and Throttle are
on the Engine Control Panel mounted on the drivers
side of the engine package
(See Figure 3-6.)
Figure 3-6: Engine Control Panel
RIGHT This position, the winch is disengaged
and the cable can “free-wheel”.
LEFT In this position, the winch is engaged
and the cable can be “power” spooled
in or out. The winch is now controlled
by the
WINCH hydraulic lever.
UP In this position, cable is “power”
spooled onto the spool.
CENTER This is neutral position.
DOWN In this position, cable is “power”
spooled off the spool.
ENGAGE DISENGAGE
clutch20
If the hydraulic fluid level is low during operation,
the semitrailer may not operate correctly,
resulting in damage to the semitrailer.