Landoll 2210, Operator'S Manual

Page: 51 / 52

5 TROUBLESHOOTING GUIDE
The Troubleshooting Guide, shown below, is included to help you quickly locate problems that can
happen using your 2210 Series Weatherproofer. Follow all safety precautions stated in the previous
when making any adjustments to your machine.
SYMPTOM PROBLEM: REMEDY
FIELD NOT LEVEL BEHIND WEATHER-
PROOFER. RIDGE AT CENTER OF SWATH
FRAME NOT LEVEL FRONT TO REAR: Lower
machine to working depth and drive a short distance.
Stop and check if frame is level. Adjust radius rod as
required to level machine.
REAR DISC GANGS AT TOO AGGRESSIVE ANGLE:
Adjust rear disc gangs to a lesser angle. REAR DISC
GANGS OPERATING TOO DEEP: Raise rear discs to
desired depth (3" to 6") REAR DISC GANGS TOO
CLOSE TOGETHER: Loosen u-bolts holding disc gang
shanks to 5 X 3 tube and slide disc gangs out.
FIELD NOT LEVEL, RIDGE AT OUTSIDE
OF SWATH
FRAME NOT LEVEL FRONT TO REAR: Lower
machine to working depth and drive a short distance.
Stop and check if frame is level. Adjust radius rod as
required to level machine.
FRONT DISC GANGS TOO AGGRESSIVE AN
ANGLE: Adjust front gangs to a less aggressive angle.
DISC GANGS OPERATING DEEPER THAN
NECESSARY: Raise front disc gang to operate at
desired depth (3" to 6").
SPEED TOO FAST FRONT DISCS THROW SOIL
BEYOND REACH OF REAR DISCS: Change to slower
gear or change front disc gangs to a lesser angle.
STRIPS OF UNTILLED SOIL NEAR
CENTER OF SWATH
FRAME NOT LEVEL FRONT TO REAR: Lower
machine to working depth and drive a short distance.
Stop and check if frame is level. Adjust radius rod as
required to level machine.
DISC GANGS OPERATING TOO SHALLOW: Lower
disc gangs to operate at deeper depth.
DISC GANGS STOP TURNING AND PLUG DISCS SET TOO SHALLOW: Lower disc gangs.
SCRAPERS SET TOO TIGHT: Adjust scrapers to touch
disc blades lightly. You should be able to turn disc gang
by hand. In wet soil or heavy residue, adjust scrapers
1/16" to 3/16" away from disc blades. DISC BLADES
WORN: New blades are 22" dia. Replace when
necessary.
SHANKS PLUG FRONT DISCS SET TOO SHALLOW: Lower discs to
get better cutting action.
SHANKS NOT SPACED CORRECTLY: See shank
placement figure. Adjust if necessary.
SCRAPERS BEND OR PLUG SCRAPERS NOT ADJUSTED CORRECTLY: Adjust
scrapers to touch disc blades lightly. You should be
able to turn disc gang by hand. In wet soil or heavy
residue, adjust scrapers 1/16" to 3/16" away from disc
blades.
SCRAPERS NOT ASSEMBLED CORRECTLY: Check
set up instructions.
5-1