Landoll 2000 Series, Operator'S Manual, Page: 19 / 42

ASSEMBLY INSTRUCTIONS
3-9
Figure 3-7: Optional Accessories Installation
Ridgers
A ridger is an optional device that can be installed on
each shank.
1. Full ridgers should be installed on the inner shanks,
and half ridgers should be mounted on the outer, end
shanks. (Half ridgers should be inside of the tool
assembly.)
2. Assemble a shank clamp (See Figure 3-7) to the
rear of each shank. Secure the bracket with u-bolts
and 5/8-11 hex lock nuts.
Anhydrous Ammonia Knives
1. The ammonia knives are mounted in the same
manner as the ridgers. They cannot be used at the
same time the ridgers are being used
(See
Figure 3-7.)
Fertilizer Tubes
1. The fertilizer tubes should be mounted on the disc
shaft assemblies. Secure with a u-bolt and 5/16-18
hex lock nuts
(See Figure 3-7.)
IMPORTANT
Be sure to raise the tubes high enough to clear the
ground to prevent plugging the tubes.
SHANK
U-BOLT
U-BOLT
OFFSET DISC
ASSEMBLY
AMMONIA KNIFE
ASSEMBLY
IRRIGATION RIDGERS
(OPTION)
FERTILIZER ATTACHMENT
5/16-18 HEX LOCK NUT
FERTILIZER TUBE
ASSEMBLY
PLASTIC TUBE END
5/8-11 HEX LOCK NUT
RIDGER ASSEMBLY
545m104602