Landoll 1230 Series, Operator'S Manual

Page: 25 / 64

3-19 HYDRAULIC SYSTEM ASSEMBLY
IMPORTANT
REFER TO THE TORQUE CHARTS TABLES 2-1
AND 2-2 FOR IMPORTANT INFORMATION ON
THE TIGHTENING OF STRAIGHT-THREAD HY-
DRAULIC FITTINGS.
DO NOT USE PIPE SEALANT OR TEFLON Ó
TAPE ON THREADS.
DO NOT CONNECT ROD ENDS OF HY-
DRAULIC CYLINDERS UNTIL AFTER THE
HYDRAULIC SYSTEM IS PURGED OF AIR
(SEE SECTION 3-19.4).
3-19.1 Disc Cutter - Rigid Models
a. Mount base end of 3" x 8" disc cutter frame
cylinder to cylinder anchor on hitch (See Fig-
ure 3-28) .
b.
Install 90 ° elbows in cutter frame cylinder.
c. Connect 3/8" x 128" and 3/8" x 140" hoses
to cutter frame lift cylinder and route through
hitch (See Figure 3-30) .
3-19.2 Wheel Lift - Rigid & 19’ Folding Models
a.
Install 90 ° elbows in main frame lift cylinder
(See Figure 3-29) .
b. Connect 3/8" x 228" hoses to main frame lift
cylinder and route through hitch.
3-13
Figure 3-28 - Cutter Frame Lift Cylinder
Figure 3-29 - Main Frame Lift Cylinder
Figure 3-30 - Hoses Routed in Hitch