Landoll 1230 Series, Operator'S Manual

Page: 27 / 64

e. Thread wing lift cylinder hoses and cutter
frame lift cylinder hoses through vertical hose
supports during assembly (See Figures 3-34
and 3-35).
f. Attach L-bracket to rear bolt of wing rock-
shaft inner bearing. Fasten wing lift cylinder
hoses to L-bracket with clamp and 3/8
″ x 2 ″
cap screw, lock washer and nut (See Figure
3-34).
g. Attach straight bracket to U-bolt at end of
wing hinge. Fasten cutter frame lift cylinder
hoses to bracket with clamp and 3/8
″ x 2 ″ cap
screw, lock washer and nut (See Figure
3-35).
h. Use plastic ties to securely fasten all hoses
at various places on frame. Keep hoses away
from potential pinch points and sharp edges.
i. All models: Purge air from hydraulic system.
3-19.4 Purging Air From Hydraulic System - Initial
Assembly
IMPORTANT!
CYLINDER OPERATION WILL BE VERY ER-
RATIC AND UNEVEN UNTIL ALL AIR IS
PURGED FROM THE SYSTEM.
After hitching the tractor to the chisel plow and
connecting the hydraulic hoses:
a. Cycle all chisel plow cylinders several times
to purge air from system.
b. Connect cylinder rod ends after purging sys-
tem.
c. Operate all lift and wing fold cylinders to
check operation.
d. Check for and correct leaks as required.
WARNING
RECHECK FLUID LEVEL IN TRACTOR
RESERVOIR AFTER FILLING AND
PURGING AIR FROM IMPLEMENT HY-
DRAULIC SYSTEM. FAILURE TO DO
SO CAN RESULT IN PERSONAL IN-
JURY AND / OR DAMAGE TO IMPLE-
MENT OR TRACTOR. ADD FLUID AS
NECESSARY.
WARNING
TO PREVENT POSSIBLE SERIOUS IN-
JURY OR DEATH, CLEAR BYSTAND-
ERS FROM AREA WHEN FOLDING
AND UNFOLD WINGS.
3-15
Figure 3-34 - Rear of RH Wing
Figure 3-35 - Front of RH Wing