8
Shelves
DISASSEMBLY
L3015UI1WSG-LH / L3015UI1WSG-RH
L3015UI1BSG-LH / L3015UI1BSG-RH
L3024UI1MSG-LH / L3024UI1MSG-RH
L3024UI1BSG-LH / L3024UI1BSG-RH
L3024UI1WSG-LH / L3024UI1WSG-RH
L3024UI2WSG-LH / L3024UI2WSG-RH
Installing the shelves
1. Open the door completely. The door must be able to
open at least 90 degrees for the shelves to properly
clear the door gasket.
2. Identify the slots corresponding to your desired
shelf height. Ensure that all four (4) track slots -left
and right, front and back - are the same height so
that your installed shelf will be level.
3. Lift the front of the shelf [closest to you] at a 20
degree angle above the back of the shelf. Insert the
rear pegs on both sides of the shelf into the rear
vertical track mounting slots as shown in step "A"
below.
4. Push the rear pegs in. Then, set the front shelf pegs
into the front vertical track mounting slots as shown
in step "B" below.
MODELS:
Removing the shelves
1. Open the door completely. The door must be able to
open at least 90 degrees for the shelves to properly
clear the door gasket.
2. Holding both the left and right sides of the shelf you
intend to remove, lift the front up out of the key slot on
the front vertical tracks. Then pull the shelf out of the
cabinet and towards you. See step "A" below.
3. Pull the shelf approximately 1/3 out of the refrigerator
cabinet. The rear shelf pegs will disengage from the rear
vertical tracks as shown in step "B" below. With the front
of the shelf angled 20 degrees above the back of the
shelf, pull the shelf forward until it is completely removed
from the cabinet.
