Landmann Cronos, Assembly And Operating Manual, Page: 13 / 28

15
12775
Troubleshooting
If there is a fault despite due care, this chapter may help you to resolve the malfunction.
Malfunction Potential causes Remedy
There is a smell of gas Leak in the gas system 1. Close the cylinder valve imme-
diately (turn G1 clockwise).
2. Prevent any flame or spark for-
mation (do not switch on any
electrical appliances)
3. Tighten all connections on the
gas system
4. Check all components of the
gas system for visible damage;
replace defective parts with
original spare parts
5. Check for leaks using a leak
detector
Burner does not light Gas cylinder is empty Replace the gas cylinder
Battery of the electronic pulse
igniter is flat
Replace the battery (type AA)
Cylinder valve is closed Open the cylinder valve (turn G1
anti-clockwise).
The nozzle on the adjusting ele-
ment (behind front panel) is not
inserted into the burner hose.
Visual test, if necessary adjust noz-
zle and connection hose.
The igniter cable is not in contact
with the electronic pulse igniter
Conduct a visual test, connect if
necessary
Distance between the spark plug
and gas outlets on the burner is
incorrect
Visual inspection; correct if neces-
sary
Nozzle on adjusting element
(underneath front panel) is
blocked.
Clean the adjuster jet with a nee-
dle
Other gas system blocked The gas system should be cleaned
by a specialist
Temperature on grill too low Pre-heating time too short Close the lid of the grill unit and
set the flame regulator to Max.
Gas outlets on the burner are
blocked
Remove blockages from the burner
Strong flare-up Fatty foods Remove any large areas of fat prior
to barbecuing or place the meat on
a grill plate or reduce the barbecue
temperature
Popping or bubbling noise Flashback caused by blockages in
the burner.
1. Close the cylinder valve imme-
diately (turn G1 clockwise).
2. Wait three minutes and then
switch the barbecue back on
3. If the malfunction reoccurs, dis-
assemble and clean the burner