6
STEP 4 - ATTACHING WIRE SHELF
Place the fire bowl upside down on the floor so that the
four legs point upwards and make sure that the short
legs are closest to you.Take the wire shelf (M) and
position it so the threaded bar is closest to your body
and the two kinks at the other end of the shelf point
upwards. Insert the kinked ends of the shelf into the
holes nearest the end of the long legs. You may need to
tilt the shelf upwards slightly to fit them in. It may be
necessary to turn the legs round to line the holes up.
Once you have done this,insert the threaded ends of
the shelf into their corresponding holes in the short
legs (closest to you). You will have to push the legs out
w
ard
slightly to do this.
STEP 5 - WHEEL ASSEMBLY
Place the wheels (L) on the threaded ends of the
wire shelf (M) and fix with wheel nuts (T) and washer (S)
tighten wheel assembly.
Note: you may have to squeeze the legs
inwards to fit the nuts on the threaded ends
STEP 6 - ASSEMBLY AIR VENT
Using bolt (R) and wing nut (U) to fit air vent (N) to the
outside of the lid.
(M)
(L)
(T)
(S)
(M)
(U)
(N)
(R)
Important: Now stand the barbecue on its
legs and fully tighten the four
screws holding the legs.
