3
Assembly Instructions
• Carefully align the side frame
cover. Working from top to bot-
tom, snap the upright side cover
into place.
• Align the side frame cover
beneath the end cap and install
the Phillips head screw.
• Tighten the Phillips head screw
until side cover aligns with
endcap.
(Do not over-tighten).
• Check the tension on the drive
belt by placing the drive belt
between your thumb and fore-
finger and twisting.
• The proper twist is 45º. If the
belt needs to be adjusted use a
7/16” socket and turn the bolt
underneath the motor pan
attached to the motor’s hook
screw.
HOME :
• Route the wire harness
under-
neath
the elevation motor and
secure with harness restraint clip
provided. Plug connector into
circuit board until it snaps
into place.
COMMERCIAL :
• Route the wire harness
behind
the elevation motor and secure
with harness restraint clip pro-
vided. Plug connector into
circuit board until it snaps
into place.
•
The treadbelt is tracked and
tensioned via the take-up screws
located at the back of the treadmill.
• Check the tension of the tread-
belt. At proper tension you
should be able to place your
hand between the belt and deck
and reach the center of the
treadmill. If you cannot reach
the center, the belt is too tight
and must be loosened. If your
hand reaches past the center the
belt is too loose and must be
tightened.
• Remove the black motor cover
screws in the side of the frame.
Place motor cover onto treadmill.
• Attach motor cover with Phillips
head screws provided. Place
rubber spacer between cover and
frame.
• Plug treadmill into a dedicated
15A outlet. Walk on treadmill at
approximately 2.5 mph for 20 to
45 minutes to properly walk
in lubricant.
STEP 7:
Snap side cover into place
STEP 8:
Install side cover screw.
STEP 9:
Check drive belt tension
STEP 10:
Route the wire harness
STEP 11:
Adjust the treadbelt
STEP 12:
Install motor cover
harness
Summary of Contents for Pro Sports Trainer
Page 23: ......
