Landice L10 90 Series, Installation Manual & Quick Start Manual

Page: 31 / 36

Treadbelt Tracking Installation
29
parallel, each is at right angles to the frame, so that the treadbelt
tension from side to side is equal as shown in the following figure. If
the treadbelt is running diagonally, with unequal gaps between the
treadbelt and sides then the rollers must be adjusted (see Figure 2-
30).
Figure 2-30. Tracking Setup
Adjustment is performed using the two adjustment screws (6mm
Allen wrench) located at rear of treadmill, see Figure 2-30. The
following provides a tracking adjustment example: Treadbelt tracks
to the right:
Note:
This example assumes that only the take-up roller is out of
alignment. You might encounter a situation in which both
rollers are out of alignment but the same process applies.
a. Turn treadmill on, and bring speed up to 2.0 mph.
90°
90°
Belt tension equal
on both sides
90° 90°
90° <90°
Belt tension
greater on left
side
Belt tension, right side
Belt tension, left side
Belt tension, right side
Belt tension, left side
Treadbelt to side gap.
Check both sides,
front and rear.
Belt forced to
the right side,
belt running
diagonally,
gaps unequal
from front to
rear.
Belt
running
true due
to equal
belt
tension.
Front,
drive
roller
Rear, take-
up roller