1 800 - LANDICE | [email protected] | WWW.LANDICE.COM
LANDICE, INC.
111 CANFIELD AVE., SUITE A-1
RANDOLPH, NJ 07869
PHONE: (973) 927-9010
FAX: (973) 927-0630
[email protected]
1.
Using a 9/16” socket and
ratchet, remove the rear take up
bolt on each side of the machine.
(
Figure A
)
2
. Grab the roller with your hand,
angle it and slide it out from inside
the treadbelt. (
Figure B)
Be careful not to drop the roller, as
bearing damage may result!
For L7 - 3/8” socket w/ratchet
For L8 - ½” socket w/ratchet
1.
Use the socket wrench to
remove the front roller bolt on both
sides of the treadmill. (
Figure A
)
2.
Angle the roller and slide the
front roller out from inside the
treadbelt (
Figure B
) You can use
the drive belt as a handle to
remove the front roller,
do not
drop!
1.
Remove the felt washers. L7 units will have 6 thick felt washers that fit on top of the deck. There are 2
additional white felt washers on the front deck post.
(Figure A)
L8 units use 8 thick felt washers.
2.
Place the handle of a rubber mallet between the deck and the frame.
(Figure B)
3.
Go to the
OPPOSITE
side and lift the deck out of the frame assembly.
4.
Slide the treadbelt out of the deck to remove it.
Revision Date 07/2020
Remove the Front Roller
Remove the Rear Roller
Remove the Deck
