96-610 • LANDA VNG/VLP • REV. 9/05
OPERA
T
OR’S MANU
AL
PRESSURE W
ASHER
12
INSTALLATION
CHECK LIST BEFORE STARTING:
WARNING
HAS ELECTRONIC
SPARK IGNITION. DO
NOT ATTEMPT TO
LIGHT MANUALLY.
CAUTION: If “NO” has been checked on any of the
above questions, do not operate the machine.
CAUTION: This machine is
equipped with an electronic ig-
nition system. Lighting of the pi-
lot is accomplished through
electronic spark ignition. Do not
attempt to light the appliance
manually as a burn injury or
electrical shock may result.
YES
NO
Has gas supply been inspected by an
authorized contractor to meet local codes?
Is machine protected from downdraft and
excessive wind?
Is machine shielded from moisture or water
spray?
Is the voltage correct and are the circuit
breaker and supply cord adequate
according to specifications and serial plate
notation?
Is the machine electrically grounded?
Is there ample water supply?
Have all flammable liquids or gases been
removed from installation location?
Is there adequate gas supply for the BTU
rating of the burner?
Is incoming gas supply pressure between
6 - 14 water column inches or 1/2 PSIG?
Has the proper gas regulator been
installed for pressure and volume?
Is the machine properly vented to allow
adequate air flow?
Are the propane tanks large enough,
according to rating to prevent freezing?
Have gas lines been checked for gas
leaks?
Have gas lines been checked with local
codes?
Have all operators using this machine
been instructed properly & have they read
the manual?
Has the machine been installed according
to operator's manual instructions?
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal
injury or loss of life.
A. This appliance has an electronic ignition system. When
lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
FOR YOUR SAFETY
"WHAT TO DO IF YOU SMELL GAS"
•
Do not try to light any appliance.
•
Do not touch any electrical switch, do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
•
If you cannot reach your gas supplier, call the fire de-
partment.
C. Use only your hand to turn the gas control. Never use
tools. If the knob will not push in or turn by hand, don't
try to repair it; call a qualified service technician. Forced
or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
Summary of Contents for VNG4-2000
Page 2: ......
Page 54: ......
Page 56: ...Form 96 610 Revised 9 05 Printed in U S A WATER CLEANING SYSTEMS...