
15
Operations
Operating Instructions
STEP 1:
STOP!
Read operator’s
manual before operating this
machine. Failure to read operation
and warning instructions may result
in personal injury or property
damage. Connect water supply
hose to inlet connector and turn
water on.
STEP 4:
Pull the spring-loaded
collar of the wand coupler collar
back to insert your choice of
pressure nozzle.
CAUTION: Never
replace nozzles without
engaging the safety latch on the
spray gun trigger.
STEP 2:
Turn all switches off.
Remove and position LP tank as far
from machine as supply hose will
allow.
STEP 5:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 3:
Before installing nozzle,
Pull trigger on spray gun allowing
water to flow until all air has been
discharged from the system. Check
for water leaks and tighten as
needed.
Grip spray gun variable pressure
wand securely. Then turn the
variable pressure control handle
counterclockwise to flush any
debris out of soap nozzle.
.
Coupler
Collar
Turn Pump/
Burner
Switch Off
Landa VHP 2-1500 / 3-2000 Operator’s Manual 8.913-949.0 - T
Variable Pressure
Control Handle
Trigger
Variable Pressure
Wand (VP)
High
Pressure
Nozzle
Brass Soap
Nozzle
STEP 6:
Selection of high or low pressure is accompanied
by turning the handle.
NOTE: High pressure nozzle must be inserted at end of
wand to obtain high pressure. To apply soap read
operator's manual.