13
Operations
Shutdown Instructions
STEP 1:
Remove detergent suction
tube from container and insert into
one (1) gallon of fresh water. Pull
trigger on spray gun and siphon
water for one minute
STEP 4:
Turn water off.
STEP 2:
Push burner switch off
and open trigger on spray gun,
allowing water to flow, which will
cool down the heating coil.
STEP 3:
After water has cooled,
turn the pump switch off.
Landa PHW Operator’s Manual 8.917-417.0 - D
PHW
PUM
P
BUR
NER
PO
WER
IGN
ITIO
N
OV
ERLO
AD
Burner
Switch
Storage
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32° F (0°C). The pump in this machine is suscep-
tible to permanent damage if frozen. FREEZE
DAMAGE IS NOT COVERED BY WARRANTY.
ATTENTION: Toujours entreposer la laveuse à
pression dans un endroit où la température ne sera
pas inférieure à X °C (X °F). La pompe sur cette
machine est susceptible de subir des dommages si
elle est exposée au gel. LES DOMMAGES DUS AU
GEL NE SONT PAS COUVERTS PAR LA
GARANTIE.
1. Stop the pressure washer, squeeze spray gun
trigger to release pressure.
2. Detach water supply hose and high pressure hose.
3. Turn on the machine for a few seconds, until
remaining water exits. Turn pump off immediately.
4. Do not allow high pressure hose to become kinked.
5. Store the machine and accessories in a room
which does not reach freezing temperatures.
CAUTION: Failure to follow the above directions
will result in damage to your pressure washer.
ATTENTION: Le non-respect des directives ci-
dessus entraînera des dommages à la laveuse à
pression.
