13
Operations
Shutting Down And
Clean-Up
STEP 1:
Remove detergent suction
tube from container and insert into
one (1) gallon of fresh water. Pull
trigger on spray gun and siphon
water for one minute.
STEP 4:
Squeeze trigger on spray
gun to relieve remaining pressure.
STEP 2:
Turn burner switch off and
continue spraying, allowing the
water to cool to below 100°F.
STEP 5:
Remove water supply
hose.
STEP 3:
Turn engine key switch off
and turn off water.
Landa PGHW Operator’s Manual 8.916-485.0 - BW
SenDEC
TACH
/HOUR
1/10
Burner
Switch
SenDEC
TAC
H/H
OU
R
1/10
Engine
Key Switch
•
Liquides contenant des solvants (c.-à-d. diluant
à peinture, essence, huiles, etc.)
•
Produits à base de tripolyphosphate de sodium
•
Ammoniac ou produits à base d'acide
These chemicals will harm the machine and will
damage the surface being cleaned.
Rinsing
It will take a few seconds for the detergent to clear.
Apply safety latch to spray gun.Select and install the
desired high pressure nozzle.
CAUTION: Removal of the pick up tube from
detergent bucket will draw air into pump causing
cavitation and low pressure.
ATTENTION: Lorsque le tube d'aspiration est retiré
du seau de détergent, de l'air sera aspiré dans la
pompe, provoquant une cavitation et une basse
pression.