14
Maintenance
Storage
CAUTION: Always store your pressure washer in a
location where the temperature will not fall below
32°F (0°C). The pump in this machine is susceptible
to permanent damage if frozen. FREEZE DAMAGE
IS NOT COVERED BY WARRANTY.
1.
Stop the pressure washer, squeeze spray gun
trigger to release pressure.
2.
Detach water supply hose and high pressure hose.
3.
Turn on the machine for a few seconds, until
remaining water exits. Turn engine off immediately.
4.
Drain the gas and oil from the engine.
5.
Do not allow high pressure hose to become kinked.
6.
Store the machine and accessories in a room
which does not reach freezing temperatures.
CAUTION: Failure to follow the above directions
will result in damage to your pressure washer.
When pressure washer is not being operated or is
being stored for more than one month, follow these
instructions:
1.
Replenish engine oil to upper level.
2.
Drain gasoline from fuel tank, fuel line, fuel valve
and carburetor.
3.
Pour about one teaspoon of engine oil through
spark plug hole, pull starter grip several times and
replace the plug. Then pull the starter grip slowly
until you feel increased pressure which indicates
the piston is on its compression stroke and leave it
in that position. This closes both the intake and
exhaust valves to prevent rusting of cylinder.
4.
Cover pressure washer and store in a clean, dry
place that is well ventilated away from open flame
or sparks.
NOTE:
The use of a fuel additive, such
as STA-BIL
®
, or an equivalent, will minimize the
formulation of fuel deposits during storage. Such
additives may be added to gasoline in fuel tank of
the engine, or to gasoline in a storage container.
After Extended Storage
CAUTION: Prior to restarting, thaw out any
possible ice from pressure washer hoses, spray
gun or wand.
Engine Maintenance
During the winter months, rare atmospheric conditions
may develop which will cause an icing condition in the
carburetor. If this develops, the engine may run rough,
lose power and may stall. This temporary condition can
be overcome by deflecting some of the hot air from the
engine over the carburetor area.
NOTE:
Refer to the
engine manufacturer’s manual for service and mainte-
nance of the engine.
1.
Check to see that water pump is properly
lubricated.
2.
Follow winterizing instructions to prevent freeze
damage to pump and coils.
3.
Always neutralize and flush detergent from system
after use.
4.
If water is known to be high in mineral content, use
a water softener on your water system, or de-scale
as needed.
5.
Do not allow acidic, caustic or abrasive fluids to be
pumped through system.
6.
Always use high grade quality cleaning products.
7.
Never run pump dry for extended periods of time.
8.
Use clean fuel-kerosene, No. 1 fuel oil, or diesel.
Clean or replace fuel filter every 100 hours of oper-
ation. Avoid water contaminated fuel as it will
damage the fuel pump.
9.
If machine is operated with smoky or eye burning
exhaust, coils will soot up, not letting water reach
maximum operating temperature.
10. Never allow water to be sprayed on or near the
engine or burner assembly or any electrical
component.
11. Periodically delime coils as per instructions.
12. Check to see that engine is properly lubricated.
It is advisable, periodically, to visually inspect the
burner. Check air inlet to make sure it is not clogged or
blocked. Wipe off any oil spills and keep equipment
clean and dry.
The flow of combustion and ventilating air to the burner
must not be blocked or obstructed in any manner.
The area around the Landa washer should be kept
clean and free of combustible materials, gasoline and
other flammable vapors and liquids.
Landa PGDC Operator’s Manual 8.916-596.0 - P
