11
Operations
Operation Instructions
STEP 1:
Read operator’s manual
before operating. Pull wand coupler
collar back, insert desired pressure
nozzle into coupler, then secure by
pushing collar forward.
CAUTION: Never replace nozzles
without engaging the safety
latch on the spray gun trigger.
ATTENTION
:
Ne jamais
remplacer les buses sans
d'abord mettre le dispositif de
sécurité sur la détente du
pistolet pulvérisateur.
STEP 4:
With the spray nozzle
pointed away from you or anybody
else, press the trigger on the spray
gun to obtain pressurized cold
water spray.
STEP 2:
Turn on water at faucet
and pull trigger on spray gun
allowing water to flow until all air
has discharged from system.
Check for water leaks; tighten as
needed.
NOTE:
Variable pressure
control wand handle must be
turned clockwise to enable water to
flow out of the high pressure
nozzle.
STEP 5:
For hot water, turn the
burner switch to ON when a steady
stream of water flows out of the
spray gun. Burner will now light
automatically.
NOTE:
Do not start
machine with burner switch on.
STEP 3:
Read engine manual. Move
fuel valve to closed or OFF position,
if equipped. To start engine, if choke
is closed, gradually move it to the
open position as the engine warms
up. Turn the engine switch to the
START position and hold it there until
the engine starts.
NOTE:
Do not use the electric starter
for more than five seconds at a time.
If the engine fails to start, release the
switch and wait ten seconds before
operating the starter again. When the
engine starts, allow the engine switch
to return to the ON position. If the
engine is to be started without the
battery, turn switch to start position
and pull rope to start. Turn off choke.
WARNING: Small engines may
kick back. Do not hold pull rope
tightly in hand. Starter cord
kickback (rapid retraction) can
result in bodily injury.
AVERTISSEMENT: Les petits
moteurs peuvent présenter un
risque de retour. Ne pas tenir
fermement le lanceur moteur. Le
retour du cordon de lancement
(rétraction rapide) peut causer des
lésions corporelles.
NOTE: Kick back will pull hand
and arm toward engine faster then
you can let go. Always relieve
spray gun pressure before pulling
starter cord.
Pull starter cord slowly until resis-
tance is felt, then pull rapidly.
Landa PGDC Operator’s Manual 8.916-596.0 - BF
High Pressure
Nozzle
Wand
Coupler
Collar
Engine
Switch
Burner
Switch Detergent
Valve
STEP 6:
Selection of high or low pressure is accompanied by turning the handle.
NOTE:
High pressure nozzle must
be inserted at end of wand to obtain high pressure.
Variable Pressure
Control Handle
Trigger
Variable Pressure
Wand (VP)
High
Pressure
Nozzle
Brass Soap
Nozzle
