Page 3
Installation Guide
Landmark Graphic Processor I/O Card
3 Installation Instructions
This section must be referred to when installing or removing an I/O Card.
Warning
Risk of electric shock.
Disconnect the processor from the a.c. mains power supply before
removing the rear panel.
Caution
Observe precautions for handling electrostatic discharge sensitive
devices.
Note
To disassemble and re-assemble the processor, a 2.5mm AF hexagonal
driver will be required.
1) Refer to Fig. 1. Unscrew the four screws (A). Retain the screws in a
safe place for re-assembly.
2) Remove the rear panel. The thermometer channel Input/Output (I/O)
card(s) and the Serial Communications card (if fitted) should now be
clearly visible.
3) Insert/remove the I/O card by sliding it into/out of the appropriate
slot in the rear of the processor.
4)
Ensure that the Serial Communications card, if fitted, is in the slot
immediately to the left of the power supply unit of the processor.
5)
Fit the rear panel onto the processor. Insert and tighten the four
hexagonal screws (A), which secure the rear panel to the processor.
