Land Pride STB1560, Operator'S Manual

Page: 14 / 36

Section 1: Assembly & Set-up
Table of Contents
11/27/18 STB1560, STB1572, STB1584 & STB1596 Snow Trip Blade 301-493M
10
Angling Options Assembly
Land Pride offers three angling options for the Snow Trip
Blade. The Snow Trip Blade must be equipped with one
of the following three angling options.
WARNING
!
To prevent serious injury or death:
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than hands
when searching for leaks. A doctor familiar with this type of
injury must treat the injury within a few hours or gangrene
may result. DO NOT DELAY.
Bent Pin Assembly
Refer to Figure 1-4:
1. Drive 1/4" x 1 3/4" roll pin (#1) through bent pin (#2).
2. Align holes on the pivot weldment and hitch
assembly to desired angle.
3. Push the bent pin assembly through holes as shown.
NOTE: The STB1596 is only offered with dual
cylinders and cushion valve option. The other two
options are not available for the STB1596.
IMPORTANT: Make sure threads and inside of
fittings and hoses are clean.
Bent Pin Assembly
Figure 1-4
39691