Land Pride SPL1060, Operator'S Manual

Page: 11 / 28

Section 1: Options & Accessory Set-up
Table of Contents
SPL1060, SPL1072, & SPL1084 Snow Pusher 303-451M 11/7/18
7
Pull Back (Optional)
Refer to Figure 1-2:
Land Pride offers an optional pull back (#1). It is shipped
complete with mounting hardware (#2 & #3). This kit will
allow operator to pull snow away from garage doors and
other objects while backing up. See Figure 1-2 for part
numbers and descriptions.
WARNING
!
To avoid serious injury or death:
•
Support pull back securely with a hoist or other lifting
device until several bolts on each side have been inserted
and secured with hex whiz nuts.
•
Be careful not to pinch fingers, hands, or other body
extremities between pull back and Snow Pusher as unit is
rotated into final mounting position.
1. Support pull back (#1) with a lifting device while
attaching its front in between the side panels with
1/2"-13 x 1 1/4" GR5 carriage bolts (#2) and hex whiz
nuts (#3). Draw whiz nuts up snug. Do not tighten nuts
at this time.
2. Lower lifting device enough to roll pullback (#1) into
position and install remaining carriage bolts (#2) and
hex whiz nut (#3).
3. Lifting device can now be removed.
4. When finished, tighten nuts (#3) to the correct torque.
Orange Markers (Accessory)
Part No. 323-026A
Refer to Figure 1-3:
Land Pride offers 28" high orange markers that can be
bolted to the side panels. These assist in locating the
outer ends of the Snow Pusher when approaching
buildings, trees, poles, and other obstacles that could
damage the attachment, tractor, or the obstacles the
Snow Pusher comes in contact with.
1. Attach orange marker (#3) to the right-hand side
panel with 5/16"-18 x 1" GR5 hex head bolts (#1) and
hex nylocknuts (#2). Tighten nylocknuts to the
correct torque.
2. Repeat step 1 for the left-hand side panel.
IMPORTANT: The flanges on the pullback may need
to be pulled together to fit pull back between Snow
Pusher side panels.
NOTE: Orange marker package cannot be used
with pull back option.
Pull Back Option
Figure 1-2
Orange Marker Assembly
Figure 1-3
Part No. Description
303-437A PULL BACK ASSEMBLY 60"
303-438A PULL BACK ASSEMBLY 72"
303-439A PULL BACK ASSEMBLY 84"
39887
39890