Section 5: Maintenance & Lubrication
SBD3596 & SBD35108 Snow Blowers 370-347M
4/9/21
37
33293
SB3596 Gearbox
SB35108 Gearbox
Level Plug
Do Not Overfill
33294
Level Plug
Do Not Overfill
Fill Plug
Fill Plug
NOTE:
Use a suction or siphon pump to drain gearbox
of oil when an oil drain plug does not exist.
35675
Shear Bolt Zerk
35676
Driveline U
-
joints
Grease every 10 hours of operation
2 - Zerks
Type of grease = Multi-Purpose
Quantity = Coat Generously
Driveline Shear Bolt
Grease every 10 hours of operation
1 - Zerk
Type of grease = Multi-Purpose
Quantity = Coat Generously
Driveline Shaft
Disconnect driveline shaft from the tractor and slide
apart. Clean and coat the inner tube of the driveline shaft
with a light film of grease and then reassemble.
Type of grease = Multi-Purpose
Quantity = Coat Generously
10
Hours
10
Hours
As
Required
Gearbox
Remove oil level plug shown with arrow. If oil is below
bottom of plug hole, add recommended gear lube
through fill plug hole until oil flows out of the hole.
Reinstall and tighten oil level plug.
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil begins to flow out of oil level plug
hole in gearbox.
NOTE:
Do not overfill! Snow Blower should be level
when checking oil. Oil expands when hot, therefore,
always check oil level when cold.
NOTE:
Use a suction or siphon pump to drain gearbox
of oil when an oil drain plug does not exist.
