Land Pride SB10 Series, Operator'S Manual

Page: 30 / 42

28
Section 6: Maintenance & Lubrication
SB1051, SB1064, SB1574, & SB2584 with S/N 881640- Snow Blowers 370-027M
2/11/21
Table of Contents
General Maintenance Information
Proper servicing and adjustment is the key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly downtime and repair.
Check all bolts after using unit for several hours to be
sure they are tight. Replace any worn, damaged, or
illegible safety labels by obtaining new labels from your
Land Pride dealer.
The parts on your Snow Blower have been specially
designed and should only be replaced with genuine Land
Pride parts. Do not alter the Snow Blower in a way which
will adversely affect its performance.
Tractor Maintenance
One of the most important things you can do to prevent
hydraulic system problems is ensure that your tractor's
reservoir remains free of dirt and contamination.
Use a clean cloth to wipe hose ends before attaching
them to your tractor. Replace your tractor’s hydraulic
filter element at the prescribed intervals. These simple
maintenances will go a long way to prevent occurrence of
control valve and hydraulic cylinder problems.
Auger & Impeller Inspection
Refer to Figure 6-1:
1. Check 3/8"-16 GR5 Impeller bolt (#3) for tightness,
Make certain it is torqued tight.
2. Check impellers (#1) for wear, structural cracks, and
breakage. Repair or replace impeller before it
causes structural damage to Snow Blower housing.
3. Check for bent impellers (#1) that are making contact
or are about to make contact with Snow Blower
housing. Repair or replace impeller before it causes
structural damage to Snow Blower housing.
4. Check auger flighting (#2A) and auger paddles (#2B)
for wear, structural cracks, bending, and breakage.
Repair or replace auger before components break-
off and are sent into the impeller or through the air.
5. Check end bearings (#6) for wear. Replace bearings
that are worn excessively.
6. Lubricate bearings as required. See lubrication
schedule for “Auger Flange Bearings” on page 33.
7. Check bearing mounting bolts (#4) for tightness.
Make certain they are tightened to the correct torque.
8. Check roller chain and sprocket (#5) for wear and
chain tightness. Replace chain and/or sprocket if
they are worn excessively. See “Roller Chain Take-
up” instructions on page 22.
Section 6: Maintenance & Lubrication
Auger & Impeller Inspection
Figure 6-1
33295