Land Pride RGR12 Series, Operator'S Manual

Page: 22 / 40

Section 2: Operating
Table of Contents
RGR12 & RGA12 Series Rotary Tillers 311-948M 1/7/19
18
Park Stand Operation
Always rotate park stand (#1) up and secure it in the up
position before operating or transporting with the tiller
attached to the tractor. Always rotate park stand down
and secure it in the down position before unhooking the
tiller from the tractor.
Set Park Stand For Transport
Always adjust park stand up before traveling with tiller
hitched to a tractor.
Refer to Figure 2-2:
1. Raise tiller up until park stand (#1) is slightly above
the ground.
2. Shut tractor down without lowering the tiller before
dismounting. Refer to “Tractor Shutdown
Procedure” on page 8.
3. Remove wire retaining pin (#2).
Refer to Figure 2-1:
4. Rotate park stand (#1) up as shown.
5. Reinsert wire retaining pin (#2) in upper holes.
6. Make sure wire retainer is caught over end of
pin (#2).
Set Park Stand For Storage
WARNING
!
To avoid serious injury or death:
An unsupported parked tiller can tip over. Always use park
stand and/or support blocks to prevent it from tipping over
onto a person.
Always rotate park stand down before unhooking the tiller
from the tractor.
Refer to Figure 2-1:
1. Lower tiller until tines are a slightly above ground.
2. Shut tractor down without lowering the tiller before
dismounting. Refer to “Tractor Shutdown
Procedure” on page 8.
3. Remove wire retaining pin (#2).
Refer to Figure 2-2:
4. Rotate park stand (#1) down.
5. Reinsert wire retaining pin (#2) in lower holes as
shown.
6. Make sure wire retainer is caught over end of
pin (#2).
7. Return to the tractor and lower tiller until it is resting
fully on the ground.
IMPORTANT: To prevent park stand from being
damaged, always store stand in the transport
position before moving tractor with tiller attached.
Park Stand in Transport Position
Figure 2-1
Park Stand in Storage Position
Figure 2-2
70292
70292