Section 1: Assembly & Set-up
11/2/18
RCP2660, RCPM2660, RCP3060 & RCPM3060: Parallel Arm Rotary Cutter: 316-111M:
18
Hydraulic Reservoir Oil Fill
The Rotary Cutter is shipped without hydraulic fluid.
1.
Park cutter on a level surface, set park brake, turn off
ignition switch, and remove switch key.
2. Remove fill cap and dipstick from reservoir and add
35 gallons of Mobilfluid 424 to the hydraulic reservoir.
Use care to ensure that dust or other foreign particles
do not contaminate the fluid.
3. Wipe dipstick clean. Fully insert it and remove. Check
oil level on dipstick. Fill with recommended oil to the
full mark. Replace fill cap and dipstick.
Transport Safety Chain
WARNING
!
To avoid serious injury or death:
Transport safety chain must remain hooked to the deck until
ready to extend parallel arms and deck cylinder. Float Switch
must be “OFF” until gauge wheels are resting on the ground.
The transport safety chain should always be hooked to
the deck hook when cutter is folded up. Otherwise, the
operating levers and/or push button switches could be
bumped or hoses could burst allowing deck to fall and
cause damage to cutter, tractor, and anyone nearby.
When unhooking the transport safety chain, make sure
the arm and deck cylinders are retracted and if available,
the Float Switch is set to “OFF”. Do not force safety chain
off the deck hook. If safety chain does not remove easily,
investigate the problem and correct before continuing.
Once unhooked, store safety chain on the storage hook.
IMPORTANT:
Any high quality mineral based
Transport Safety Chain Shown in Storage Position
Figure 1-8
Transport Safety Chain Shown Hooked for Transport
Figure 1-9
12443
Transport Safety Chain
Storage Hook
Fill Cap With Dip Stick
Drain Plug
22031
Deck Hook
Transport Safety Chain
Summary of Contents for RCP2660
Page 72: ......
Page 73: ......
Page 74: ...Corporate Office P O Box 5060 Salina Kansas 67402 5060 USA www landpride com ...