Land Pride RC4710, Operator'S Manual

Page: 54 / 72

Section 5: Maintenance & Lubrication
RC(L)4710 & RCM(L)4710 Rotary Cutters 334-863M 7/31/20
50
Table of Contents
Hitch Wear Points
Before each use, check the wear points for the specific
hitch on your cutter. Replace worn hitch components as
needed. Order only genuine Land Pride parts from your
local Land Pride dealer.
Swivel Clevis Hitch Wear Point
Refer to Figure 5-13:
On the Swivel Clevis Hitch, check plate (#1) for excessive
wear around underside of radius by hitch pin hole. If the
thickness of plate (#1) is worn down to 9/16" (14 mm) or
less at the hitch pin hole, the hitch must be replaced.
LP Performance Hitch Wear Points
Refer to Figure 5-14:
On the LP Performance Hitch, check plate (#1) for
excessive wear. If the thickness of plate (#1) is worn
down to 1/2" (13 mm) or less at the hitch pin hole, the
hitch must be replaced.
Check for excessive wear on flat washer (#2). Replace as
needed.
Bar-Tite Hitch Wear Points
Refer to Figure 5-15:
On the Bar-Tite Hitch, check plates (#1 & #2) for
excessive wear. If the thickness of the plates are worn
down to 3/8" (10 mm) or less at the bolt hole, the hitch
must be replaced.
Check for excessive wear on flat washer (#3). Replace as
needed.
Swivel Clevis Hitch Wear Point
Figure 5-13
LP Performance Hitch Wear Points
Figure 5-14
Bar-Tite Hitch Wear Points
Figure 5-15
72215
70569
70570