Section 1: Assembly & Set-up
RC(L)4710 & RCM(L)4710 Rotary Cutters 334-863M
7/31/20
26
Hook-up LED Lights
Refer to Figure 1-27:
The lead wiring harness (#13) is equipped with a 7-pin
plug for connecting to the tractor’s 7-pin electrical outlet
shown in Figure 1-28.
1. Route lead wire harness (#13) through spring hose
loops (#14).
2. Connect plug on lead wire harness (#13) to the
tractor’s 7-pin electrical outlet.
3. It is best to have a second person verify the lights are
operating. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber lights are
blinking on and off.
Refer to Figure 1-29:
4. If the lights did not operate properly, recheck hook-up
of enhance module and wire harnesses. Make
necessary changes and repeat step 3 above.
a. Make sure connector (#9R) with a red wire is
connected to end labeled “ENHANCER” of wire
harness (#8R), for LED light on implement’s right
side.
b. Make sure connector (#9L) with a yellow wire is
connected to end labeled “ENHANCER” of wire
harness (#8L), for LED light on implement’s left
side.
c. Make sure connector on the lead wire harness
(#13) is connected to connector (#9C) on
enhancer module (#9).
d. Ensure that the 7-pin plug of 15'
lead wire harness
(#13) is properly seated inside 7-pin electrical
outlet on tractor (not shown).
5. Check wire harness routing to make sure wires will
not be pinched as wing deck is folded and unfolded
and while raising and lowering cutter height.
6. Secure harness in place with spiral hose wrap (#12)
and add cable ties as needed.
LED Hookup
Figure 1-27
72472
Tractor 7-Pin Electrical Outlet
Figure 1-28
Enhance Module Wire Connections
Figure 1-29
Remove Shipping Lugs
Refer to Figure 1-30:
Tie down lugs are installed on the rear two corners of the
center deck for shipping purposes only. They should be
removed and discarded before cutter is put into use.
1. Locate both rear shipping lugs on underside of center
axle. Remove and discard both shipping lugs (#1)
and attaching hardware (#2 & #3).
Rear Shipping Lug Removal
Figure 1-30
72210
NOTE:
Some center axle options may have the
shipping lugs permanently integrated into axle
frame.
72468
