45
Section 6: Specifications & Capacities
9/6/17
RC2512 Series 2 S/N Rotary Cutters 330-725M
Section 6: Specifications & Capacities
RC2512 Series 2
Specifications & Capacities
Min. power take-off horsepower
40-100 hp
Gearbox horsepower
Splitter
Center & wings
160 hp
100 hp
Gearbox shafts
Input shaft
Output shaft
1 3/8" 6 Spline
1 1/2"
Gearbox capacity & lubrication
Splitter
Center & wings
4.5 pints of gear lube 80-90W EP
4 pints of gear lube 80-90W EP
Cutting capacity
1 1/2"
Hitch weight
793 lbs.
Machine weight
2,540 lbs.
Blade tip speed At 540 rpm
Center Blades = 16,500 FPM
Wing Blades = 16,000 FPM
Hitch types
LP Performance hitch and swivel hitch
Hitch jack
Standard (2,000 lbs.)
Cutting width
Overall cutter width
Minimum transport width
12'-0"
12'-7"
7'-11" With front cutting blade 1 1/2" off the ground.
Overall length
13'-3"
Deck height
11"
Cutting height
1 1/2" to 12"
Lift hydraulics
2 1/2" x 8" hydraulic cylinder, hoses, fittings & stroke control spacers
Wing folding hydraulics
2" x 8" hydraulic cylinders, hoses & fittings
Wing flex
22
o
Down and 45
o
up while cutting.
Wing transport protection
Wing transport locks
Deck material
10 Gauge deck
Side skirt material
3/16" Plate
Skid shoes
Wing deck: 1 replaceable per wing
Center deck: 2 replaceable shoes
Blade rotation
Left wing
Center deck
Right wing
Counterclockwise
Counterclockwise
Clockwise
Blades - 6 (2 per deck)
1/2" x 3" Heat treated free swinging alloy Steel with up lift
Blade overlap
6"
Blade bolt
Keyed with hardened flat washer & lock nut
Stump jumper / blade holder
10 Gauge round dish shaped pan, reinforced
with 1" x 3 1/2" blade bar
Front & rear guards
Single chain
Input driveline
Category 4 with constant velocity u-joint
Intermediate & wing frivelines
Category 3 with slip-clutch
Wheels
20.5" x 6.75" x 10" used aircraft tires or 21" laminated wheels
Number of wheels
4 - Wheels: 2 on transport axle and one on each wing axle
Transport axle
Spring-cushioned lift cylinder
Signal lights
7 Pin connector
LED
SAE J560 pin configuration
Hubs
Cast iron five-bolt hubs with tapered roller bearings and 1 3/4" shafts.
