Land Pride QH05 Series, Operator'S Manual

Page: 19 / 38

Section 1: Assembly & Set-Up
Table of Contents
QH05, QH16, QH20, & QH30 Quick Hitches 320-003M 7/15/22
15
Hook-up Without Floating Top Links
Refer to Figure 1-6:
1. Make certain implement’s lower hitch pins are
secured in their respective clevis.
2. Place Quick Hitch release handles in the down
position as shown.
3. Lower tractor’s 3-point lift arms until auto-lock hooks
are below implement’s lower hitch pins and upper
hook is below the upper hitch point.
4. Carefully back tractor to align auto-lock hooks under
implement’s lower hitch pins and upper hook below
upper hitch point.
5. Slowly raise 3-point lift arms until auto-lock hooks
lock onto the implement’s lower hitch pins and upper
hook captures implement’s upper hitch point.
6. If required, follow implement guidelines for driveline
hook-up and required driveline length.
IMPORTANT: Make sure lower hitch pins are fully
seated in the auto-lock hooks with auto locks
popped out over the hitch pins. Also, make sure
upper hitch point is fully captured in the Quick Hitch
upper hook.
IMPORTANT: When hooking-up a driveline, make
sure its maximum allowable length does not exceed
guidelines. For detailed instructions, refer to
“Driveline Hook-up”
in your implement Operator’s
Manual. Replace driveline if it is too short. See your
nearest Land Pride dealer for a new driveline.
QH16 Implement Hook-Up
Figure 1-6
78444
Standard Cat. l Configuration:
Connect Upper Hook to Upper Hitch Point.
Auto-Lock Hooks
Upper Hook
Release Handles
Upper Hitch Point
Lower Hitch Pins
Hook-up With Floating Top Links
1. Complete steps 1-6 on the left side of this page
except the tractor’s top center link must be shortened
to keep the Quick Hitch upper hook from capturing
the implement’s upper hitch point.
2. Attach floating top links to the Quick Hitch and
implement. Refer to
“Floating Top Link”
on page 23
for detailed instructions.