Land Pride PR1048, Operator'S Manual

Page: 21 / 40

Section 1: Assembly & Set-Up
Table of Contents
6/19/23 PR1048 & PR1060 Powered Rakes 314-299M
17
Disconnect Powered Rake
Refer to Figure 1-7:
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while connecting and disconnecting
the implement. Keep people and animals away while backing-
up to the implement or pulling away from the implement. Do
not operate hydraulic controls while a person or animal is
directly behind the power machine or near the implement.
WARNING
!
To avoid serious injury or death:
•
Always shut tractor down according to “Tractor Shutdown
Procedure” provided in this manual before allowing
anyone, including the operator, to connect or disconnect the
implement.
•
Hydraulic fluid under high pressure will penetrate the skin
or eyes causing serious injury. Wear protective gloves and
safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood, rather than
hands, when searching for leaks. If an accident occurs, seek
immediate emergency medical care or gangrene may result.
DO NOT DELAY.
1. See “Long-Term Storage” on page 27 before
parking Powered Rake for a long period.
2. Shut down tractor. Refer to “Tractor Shutdown
Procedure”
on page 11.
Disconnect Powered Rake (Shown with Optional Hydraulic Angle Kit)
Figure 1-7
Center
3-Point Link
3-Point
Lift Arms
Power
Take-off Shaft
Drawbar
78833 37298
Customer supplied center 3-point hitch pin & keeper pin
Quick Hitch bushing
3. Adjust stand (#5) to stabilize Powered Rake. Refer to
“Stand Adjustments” on page 22 if needed.
Continue with steps 4-5 for hydraulic angling option.
Skip ahead to step 6 for manual angling option.
4. Disconnect quick disconnect couplers (#4) from
tractor duplex outlet.
5. Wrap hydraulic hoses around Powered Rake hitch
frame for storage and to keep dirt away from quick
disconnect couplers.
6. Push in on driveline yoke push pin (#3) and hold
while pulling driveline yoke from tractor power take-
off shaft.
7. Remove center 3-point hitch pin keeper and hitch pin
from center clevis and center 3-point link. If provided,
place center 3-point link in tractor’s holding clip.
8. Remove linchpins (#1) from hitch pins (#2). Remove
lower 3-point lift arms from lower hitch pins (#2).
9. Drive tractor forward several feet. Place gear selector
in park or set park brake, shut tractor engine off,
remove switch key, and dismount tractor.
10. Reinstall linchpins (#1) into hitch pins (#2) for safe
keeping.
11. Collapse driveline by pushing tractor end of driveline
towards the Powered Rake.
12. Support collapsed driveline off the ground to keep
dirt away from yoke push pin, u-joint, and splines.