2
Post Hole Digger Storage Stand Assembly Instructions Manual No. 317-189M
10/06/08
Land Pride
PD10 Assembly
■
PD10 Assembly
Part No. 317-166A
A detailed listing of parts for this accessory kit is
provided on page 3. Use the list as a checklist to
inventory parts received. Please contact your local
Land Pride dealer for any missing hardware.
Refer to Figure 1 on page 1:
The optional storage stand may be used when PD10
Post Hole Digger is not in operation. It will help
prolong digger’s life by keeping the unit off the
ground where moisture and debris are more likely to
collect causing undue damage to the digger. Also,
the storage stand aids in mounting and dismounting
the Post Hole Digger to and from the tractor.
PD10 Storage Stand Assembly
Refer to Figure 3:
The Storage Stand Assembly consists of an A-frame
storage stand (#7), clamping knobs (#13), cradle
(#5), and a bag of (4) - 5/16” x 3/4” long bolts.
1.
Unscrew locknuts (#10) and remove
1/2"-13 x 3 1/2" GR5 hex head bolts (#9). Slide
auger (#1) off of gearbox output shaft.
2.
Remove existing hex head cap screws (#8),
lockwashers (#11) and flat washers (#12) from
underside of gearbox. Remove auger guard (#3).
3.
Position cradle (#5) between auger guard (#3)
and gearbox (#14). Make sure cradle pins (#2)
are positioned to the back as shown.
4.
Use four new hex head bolts (#8), lock
washers (#11) and flat washers (#12) in
hardware bag to attach cradle (#5) and existing
guard (#3) to gearbox (#14).
5.
Reattach auger to gearbox output shaft with
existing auger bolts (#9) and locknuts (#10).
PD10 Storage Stand Operation
Refer to Figure 3:
Lower auger tip to the ground at the location you plan
to disconnect the Post Hole Digger from the tractor.
Set tractor park brakes, turn tractor engine off, and
remove ignition key before dismounting tractor.
Always chock tractor wheels for an extra measure of
safety if you stop on a gentle slope.
Attach storage stand (#7) to cradle (#5).
1.
Make certain guide slots (#6) at end of storage stand are
securely positioned over cradle pins (#2). Secure
storage stand to cradle with clamping knobs (#13).
2.
Without starting the tractor, lower boom (#4) to rest yoke
hitch pins securely in support angles on the storage
stand. Some adjustment to the support angles may be
required.
3.
Disconnect three-point hitch.
4.
Start tractor and drive away being careful not to catch on
the Post Hole Digger and Storage Stand.
PD10 Storage Stand Assembly
Figure 3
NOTE: Do not disconnect Post Hole Digger from a
tractor on a steep slope. Injury to personnel and
equipment may result.
20867
