![background image](http://html1.mh-extra.com/html/land-pride/os1548/os1548_operators-manual_3523864019.webp)
Section 1: Assembly & Set-up
OS1548 and OS1572 Overseeder (S/N ) 308-303M
11/28/18
15
Always engage power take-off at low engine rpm to
minimize driveline start-up torque.
Drivelines with
friction clutches must go through a “run-in”
operation prior to initial use and after long periods of
inactivity
. See
If the Overseeder is used on more than one tractor, an
additional driveline may be required - especially if a
Quick Hitch is used.
DANGER
!
To avoid serious injury or death:
•
Do not engage power take-off while hooking-up or
unhooking the driveline, or while someone is standing near
the driveline. A person’s body and/or clothing can become
•
Tractor power take-off shaft shield, driveline shields, and
gearbox shaft shields must be installed and in good working
condition to avoid driveline entanglement and projectiles
•
Do not use a power take-off adapter. The adapter will
increase strain on the tractor’s power take-off shaft causing
possible damage to shaft and driveline. It will also defeat
the purpose of the tractor’s power take-off shield.
WARNING
!
To avoid serious injury or death:
Always shut tractor down using “Tractor Shutdown
Procedure” provided in this manual before dismounting
CAUTION
!
To avoid minor or moderate injury: Some tractors are
equipped with two power take-off speeds. Do not exceed 540
rpm power take-off speed or equipment breakage may result.
Figure 1-12
Figure 1-13
IMPORTANT:
An additional driveline may be
required if implement will be attached to more than
one tractor.
Implement End
Tractor End
Pull Collar Coupling (#9)
Pull Collar Coupler (#8)
With
Slip Clutch Protection
22235
Implement End
Tractor End
Push Pin Coupling (#10)
Pull Collar Coupler (#8)
With
Slip Clutch Protection
22234
Tractor Hook-Up
Figure 1-11
33047
37298
70128