![background image](http://html2.mh-extra.com/html/land-pride/mp10/mp10_operators-manual_3600720013.webp)
Section 1: Assembly & Set-up
MP10 & MP20 Moldboard Plows 307-244M
10/29/18
9
Optional Coulter Assembly (MP20 Shown)
Figure 1-6
Coulter Assembly (Optional)
307-241A COULTER
ASSEMBLY
CAUTION
!
To avoid minor or moderate injury:
Coulter blades are sharp and can cause deep cuts. To prevent
serious bodily injury, wear gloves when working with coulters
and keep bodily extremities out from under the coulters.
Trash build-up in the plow will eventually plug the plow
and require manual cleaning. Coulters cut through the
trash making it easier for the trash to pass through the
plow. They also help reduce pulling forces and create a
smooth furrow wall.
1.
Attach coulter and offset shank assembly (#3) to
beam (#4) as shown with coulter clamp (#2),
5/8"-11 x 2 1/2" GR5 hex head bolts (#1), lock
washers (#5), and hex nuts (#6).
2. Rotate shank (#3) until coulter is in line with the share
point.
3. Tighten hex nuts (#6) to the correct torque.
4. Repeat steps 1-3 to attach MP20 rear coulter (#8) to
beam (#7).
a. Secure bolts with hex locknuts (#1A & #1B).
Tighten hex locknut (#1A) to the correct torque.
Tighten hex locknut (#1B). Do not bend top link
frames (#6 & #9) while tightening locknut (#1B).
39504
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1.
Reduce engine speed and disengage power take-off
if engaged.
2. Park tractor and implement on level, solid ground.
3. Lower implement to ground or onto non-concrete
support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7.
Use steps, grab-handles and anti-slip surfaces when
stepping on and off the tractor.