10
Section 2: Accessory Equipment Set-up
LR3784 & LR3796 Landscape Rakes 302-337M
2/26/16
Table of Contents
Dual Gauge Wheel Installation
Refer to Figure 2-1:
1.
Attach gauge wheel support arm (#2) on the right-
hand side of rake mount (#3) with six 3/8"-16 x 2 3/4"
GR5 hex head cap screws (#4), interior/exterior
toothed lock washers (#6), and hex nuts (#5). Tighten
hex nuts to the proper torque.
2.
Insert two bushings (#8) into gauge wheel arm (#2)
as shown.
3.
Insert yoke spindle (#1) thru two 1" spacers (#10),
inserted bushings (#8), two 1" Spacers (#10), and
1/2" spacer (#9) as shown. Secure with wire retaining
pin (#7). Make certain wire retainer is fastened over
end of pin.
4.
Repeat steps 1 through 3 to attach gauge wheel
assembly on the left-hand side of rake.
Grader Blade Installation
The grader blade can be attached directly to the dual
gauge wheel arms. If gauge wheels are not installed on
the Landscape Rake, grader blade support arms must be
purchased and mounted to the rake before the blade can
be installed.
Grader Blade Set-up with Gauge Wheels
Refer to Figure 2-2:
1.
Refer to
“Dual Gauge Wheel Installation”
on this
page to assemble Dual Gauge Wheels.
2.
Attach blade lock handle (#1) to the right and left-
hand Gauge Wheel Arms (#3) with 1/2" x 3" GR5 hex
bolts (#4), lock washers (#8), and hex nuts (#6) as
shown. Tighten hex nuts to the proper torque.
3.
Insert bent pins (#9) through top hole of gauge wheel
arms (#3). Secure with hairpin cotters (#10).
4.
Attach both right and left sides of grader blade (#2) to
gauge wheel arms (#3) with 3/4"-10 x 2 3/4" GR5 hex
bolts (#5) and lock nuts (#7) as shown. Draw lock
nuts up snug, do not tighten.
5.
Refer to
“Side Plate Assembly to Grader Blade”
on
page 11 for attaching side plates to both ends of
grader blade.
NOTE:
The gauge wheel arms are positioned in
from the end about 7 1/2".
NOTE:
See
“Grader Blade Set-up without Gauge
Wheels”
on page 11 if Dual Gauge Wheels are not
installed.
Section 2: Accessory Equipment Set-up
Dual Gauge Wheel Assembly
Right-Hand Assembly Shown
Figure 2-1
Grader Blade Assembly with Gauge Wheel
Right-Hand Side Shown
Figure 2-2
39421
33841
