Land Pride LR16 Series, Operator'S Manual, Page: 15 / 30

Section 2: Accessory Equipment Set-up
Table of Contents
LR1660, LR1672, LR1684 & LR1696, LR2684 & LR2696 Landscape Rakes 302-305M 11/27/18
11
Hydraulic Angling Kit
Refer to Figure 2-1:
The Hydraulic Angling Kit can be easily attached to the
Landscape Rake to make controlling the rake angle
easier. Order the kit that matches your Landscape Rake
serial number. See
“Hydraulic Angle Kits” on page 21.
DANGER
!
To prevent serious injury or death:
Do not remove hardware securing rake pivot cap without
supporting underside of the rake. The rake will fall if not
supported.
WARNING
!
To prevent serious injury or death:
Never fully extend or retract hydraulic cylinder(s) without
first checking to make sure the implement does not make
contact with tractor tires. Extending implement into the
tractor tires can result in loss of control and damage to the
implement and/or tractor.
1. Support rake by lowering unit to the ground. If
unhooked from a tractor, make sure park stand is
rotated down and secured.
2. With rake supported to keep it from falling, remove
hex flange cap screw (#20), pivot cap (#3), and drive
pivot cap (#6). Keep nut and pivot cap for reuse.
Store drive pivot cap (#6).
3. Attach hydraulic angle plate (#5) to rake pivot
shaft (#7) with pivot cap (#3) and 3/4"-10 x 1 1/2"
GR5 hex flange cap screw (#20), 3/4"-10 x 5 1/2"
GR5 bolts (#8), and hex flange top locknuts (#9).
Tighten locknuts (#9) and hex flange cap screw (#20)
to the correct torque.
4. Remove hairpin cotter (#13), hitch pin (#12), hex
flange locknuts (#11), and bolts (#10). Store removed
hardware with hex drive pivot cap (#6).
5. Attach front cylinder mount (#4) with new
1/2"-13 x 3 1/2" GR5 cap screws (#10) and hex
locknuts (#11). Tighten locknuts to the correct torque.
6. Attach adapter fittings (#16) to one end of hydraulic
hoses (#18 & #19) and tighten.
7. Attach quick disconnect couplings (#17) to adapter
fittings (#16) and tighten. (Quick disconnect
couplings are furnished by customer)
8. Position hydraulic cylinder (#14) with ports on top
and cylinder base to the front as shown. Screw 90
o
elbows (#15) into the cylinder ports and tighten
facing forward as shown.
9. Attach short hydraulic hose (#18) to elbow (#15) at
the cylinder base and tighten.
10. Attach long hydraulic hose (#19) to elbow (#15) at the
cylinder rod end and tighten.
11. Attach base of hydraulic cylinder (#14) to the front
cylinder mount (#4) with clevis pin (#2) and hairpin
clip (#1). Make sure hydraulic ports are positioned on
top and cylinder base is positioned to the front.
IMPORTANT: Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
Hydraulic Rake Angling Accessory (LR16 Series Shown)
Figure 2-1
33839
Pivot bushing (#24), also shown in
Figure 1-1 on page 8, is supplied
with LR16 Series rake only.
Section 2: Accessory Equipment Set-up