Land Pride FDR1648 Series, Operator'S Manual

Page: 32 / 40

Section 5: Maintenance & Lubrication Important Safety Information
Table of Contents
FDR1648, FDR1660 & FDR1672 Rear Discharge Grooming Mowers 310-366M 12/2/21
28
V-Belt Installation
Figure 5-4
V-Belt Installation
Refer to Figure 5-4:
These illustrations are also on the labels located on the
top of the mower decks.
1. Remove the right-hand and the left-hand belt covers.
2. Disengage belt tension by loosening eyebolt (#1) and
removing the spring (#3) from tension-chain link (#2).
3. With tension relieved from the belt, remove old belt
from pulleys.
4. Install new belt looping the belt over the pulleys as
shown.
5. Make sure the belt is positioned in all the pulley
grooves and then engage belt tension by assembling
tension spring (#3) to tension-chain-link (#2) and
chain-link to eyebolt (#1). Tightening eyebolt to apply
tension to the new belt.
6. To check belt tension, refer to
“Belt Tension”
on
page 25.
7. Reinstall all belt covers and secure in place with
hardware.
20821
Long-Term Storage
Clean, inspect, service, and make necessary repairs to
the implement when storing it for long periods and at the
end of the season. This will help to ensure the unit is
ready for field use the next time you hook-up to it.
1. Always shut tractor down according to
“Tractor Shut
Down Procedure”
on page 23 before dismounting
the tractor.
2. Clean off any dirt or grease that may have
accumulated on the deck and moving parts. Scrape
off compacted dirt from the bottom of the deck and
then wash the surface thoroughly with a garden hose.
A coating of oil may also be applied to the lower deck
area to minimize oxidation.
3. Check blades and blade bolts for wear and replace if
necessary. See “Blade Maintenance” on page 26.
4. Inspect mower for loose, damaged, or worn parts
and adjust or replace as needed.
5. Repaint parts where paint is worn or scratched to
prevent rust. Ask your Land Pride dealer for aerosol
touch-up paint. Paint is also available in touch-up
bottles with brush, quarts, and gallon sizes by adding
TU, QT, or GL to the end of the Aerosol part number.
6. Replace all damaged or missing decals.
7.
Lubricate as noted in the
“Ordering Replacement
Parts” portion of this section starting on page 28.
8. Store mower on a level surface in a clean, dry place.
Inside storage will reduce maintenance and make for
a longer mower life.
9. Follow all unhooking instructions on page 24 when
disconnecting tractor from mower.
Ordering Replacement Parts
Land Pride offers equipment in factory standard Beige
with black highlights. This implement is also available in
Orange.
When ordering an optional color, the suffix number
corresponding to the color must be added at the end of
the part number. Parts ordered without the suffix number
will be supplied in factory standard colors.
For example, if you are ordering a replacement part with
part number 555-555C and the existing part is orange,
then add the suffix 82 to the end of the number to make
the part number read 555-555C82.
Land Pride Touch-up Paint
Part No. Part Description
821-011C PAINT LP BEIGE SPRAY CAN
821-066C PAINT ORANGE SPRAY CAN
821-070C PAINT GP GLOSS BLACK SPRAY CAN
82 . . . . . . . Orange 85. . . . . . . Black