2
Important Safety Information
FD1548 & FD1560 3-Spindle Grooming Mower 310-155M
7/18/08
Land Pride
Table of Contents
Transport
Machinery Safely
▲
Comply with state and local laws.
▲
Maximum transport speed for
implement is 20 mph. DO NOT
EXCEED. Never travel at a speed
which does not allow adequate
control of steering and stopping.
Some rough terrains require a
slower speed.
▲
Sudden breaking can cause a
towed load to swerve and upset.
Reduce speed if towed load is not
equipped with brakes.
▲
Use the following maximum
speed - tow load weight ratios as
a guideline:
▲
20 mph when weight is less than
or equal to the weight of tractor.
▲
10 mph when weight is double
the weight of tractor.
▲
IMPORTANT: Do not tow a load
that is more than double the
weight of tractor.
Use Safety
Lights and Devices
▲
Slow moving tractors, self-
propelled equipment, and towed
implements can create a hazard
when driven on public roads. They
are difficult to see, especially at
night.
▲
Flashing warning lights and turn
signals are recommended
whenever driving on public roads.
Use lights and devices provided
with implement.
Practice Safe Maintenance
▲
Understand procedure before
doing work. Use proper tools and
equipment, refer to Operator’s
Manual for additional information.
▲
Work in a clean dry area.
▲
Lower the implement to the
ground, put tractor in park, turn off
engine, and remove key before
preforming maintenance.
▲
Allow implement to cool
completely.
▲
Install all transport locks on raised
drill before working underneath, refer
to the Operator’s Manual for quantity
and location of transport locks.
▲
Do not grease or oil implement
while it is in operation.
▲
Move the opener handle to the
“ROAD” position and complete
raising the openers to lock them
up before working underneath
them.
▲
Disk edges are sharp. Be careful
when working in this area.
▲
Disconnect battery ground cable
(-) before servicing or adjusting
electrical systems or before
welding on implement.
▲
Inspect all parts. Make sure parts
are in good condition & installed
properly.
▲
Remove buildup of grease, oil or
debris.
▲
Remove all tools and unused pars
from implement before operation.
