Section 1: Assembly & Set-up
CB0654 4-in-1 Combination Bucket 381-218M
1/3/23
9
Section 1: Assembly & Set-up
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1. Reduce engine speed and shut-off all power to the
attachment.
2. Park tractor and attachment on solid, level ground.
3. Lower attachment until it is flat on the ground or on
non-concrete support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7.
Use steps, grab-handles and anti-slip surfaces when
stepping getting on and off the tractor.
Pre-Assembly Checklist
Check
Ref.
Have a hoist, forklift or loader with properly sized chains and
safety stands capable of lifting and supporting the equipment
on hand.
Have a minimum of two people available during assembly.
Make sure all major components and loose
parts are shipped with the machine.
Operator’s
Manual
381-218M
Double check to make sure all parts, fasteners
and pins are installed in the correct location to
lessen the chance of using a bolt incorrectly,
Refer to the Parts Manual if unsure.
Parts Manual
381-218P
Make sure working parts move freely, bolts are
tight & cotter pins are spread.
Operator’s
Manual
381-218M
Make sure all safety labels are correctly
located and legible. Replace if damaged.
Tractor Requirements
The CB0654 bucket is designed exclusively for attaching
to Kubota’s B01 and B50 series tractors with a front
loader.
Kubota Tractor:
B01 and B50 Series Tractors With a Front Loader
Hitch Requirement:
Universal Quick Attach
Hydraulic Outlets On Loader Bulkhead:
1 Male & 1 Female Pioneer Coupler: Kit # 381-194A
1 Male & 1 Female 3/4" Flat Face Coupler:
Kit # 381-233A
Tractor Weight:
See Warning Note Below
WARNING
!
To avoid serious injury or death:
•
Consult your power machine Operator’s Manual for
operating capacity, lifting capacity, and operating
specifications. Exceeding rated capacities and
specifications can result in loss of control, roll-over or other
•
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward and/
or side tipping. Consult your power machine Operator’s
Manual to determine proper weight requirements and
Before You Start
WARNING
!
To avoid serious injury or death:
Allow only persons to operate this attachment who have fully
read and comprehended this manual, and who have been
properly trained in the safe operation of this attachment.
Serious injury or death can result from failure to read,
understand, and follow instructions provided in this manual.
Read and understand the operator’s manual for your
bucket. An understanding of how it works will aid in
assembly and setup of your bucket.
It is best to go through the
Pre-Assembly Checklist
below before assembling the bucket. Speed up your
assembly task and make the job safer by having all
needed parts and equipment readily at hand.
Torque Requirements
“Section 8: Torque Values Chart”
to
determine correct torque values when tightening
hardware.
