Land Pride CA0548, Operator'S Manual

Page: 15 / 30

Section 1: Assembly and Set-Up
Table of Contents
CA0540, CA0548 & CA0556 Core Aerators 325-108M 2/12/21
11
CA0556 Rotor Shaft Assembly
These instructions are for the 56" Aerator. See “CA0540
Rotor Shaft Assembly”
on page 9 for 48" Aerator and
“CA0548 Rotor Shaft Assembly” on page 10 for 48"
Aerator.
Refer to Figure 1-6:
1. Turn hitch and weight tray upside down and orient as
shown. Position end panel (#1A) on the left end of the
weight tray to begin assembly of the rotor shaft.
2. Insert rotor shaft (#5) in end panel (#1A)
3. Install 1" flat washer (#6A), gang assembly (#2A),
1" flat washer (#6), spacer (#4), and second flat
washer (#6) on rotor shaft (#5).
4. Install gang assembly (#2B), 1" flat washer (#6),
center support (#3), and second flat washer (#6) on
the rotor shaft.
IMPORTANT:
Make sure all gang assemblies (#2)
are installed on rotor shaft (#5) with the open side of
the spoons facing forward in rotation as shown.
5. Install gang assembly (#2C), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
6. Install gang assembly (#2D), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
7. Install gang assembly (#2E), 1" flat washer (#6),
center support (#3), and second flat washer (#6) on
the rotor shaft.
8. Install gang assembly (#2F), 1" flat washer (#6),
spacer (#4), and second flat washer (#6) on the rotor
shaft.
9. Install gang assembly (#2G) and 1" flat washer (#6B)
on the rotor shaft.
10. Install end panel (#1B) on the right end of the rotor
shaft (#5).
CA0548 Rotor Shaft Assembly
Figure 1-6
30016
Direction of
Rotation