Section 1: Assembly & Set-Up
Table of Contents
1/30/19
BS10, BS20, BSE10, & BSE20 Bale Spears 319-062M
6
4. Apply multi-purpose grease all around and along the
full inside length of spike mounting tubes (#7).
5. Rotate bale spikes (#3) so that the flat surfaces (#8)
are facing up. Insert that end into lower mounting
tubes (#7).
6. Tighten 7/16"-14 x 1" GR2 cap screws (#5) to the
correct torque value.
Single Spear With Dual Spikes Installation
Figure 1-2
Dual Spear Assembly
(BS20 & BSE20 Models)
Refer to Figure 1-1 & Figure 1-3:
1.
Apply multi-purpose grease all around and along full
inside length of tapered holes (#4).
Refer to Figure 1-3:
2. Insert spears (#3) into tapered holes (#4). Rotate
spear so that a flat surface is up and secure with
M30 x 2 eccentric hex nuts (#2).
3. Tighten eccentric nuts (#2) to the correct torque. See
“Additional Torque Values”
on page 16.
Dual Spear Installation
Figure 1-3
35018
IMPORTANT:
Do not apply grease to chamfered
surfaces of eccentric hex nut (#2) and chamfered
end of spear mounting tube (#7).
IMPORTANT:
Install eccentric hex nut (#2) with
chamfer facing spear mounting tube (#4).
35019
Section 1: Assembly & Set-Up
Installation
The BS10 & BS20 Bale Spears are designed to fit on Skid
Steer style hitch plates and BSE10 and BSE20 are
designed to fit on Euro style hitch plates.
The BS10 & BSE10 are equipped with a single center
bale spear and two lower bale spikes to keep the bale
from rotating on the spear.
The BS20 and BSE20 are equipped with two bale spears
mounted at the bottom of the units.
WARNING
!
To avoid serious injury or death:
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward tipping
or side tipping caused by a heavy front load. Consult your
power machine Operator’s Manual to determine proper
weight requirements and maximum weight limitations.
Torque Requirements
Refer to
“Torque Values Chart”
on page 16 to
determine correct torque values for common bolts.
Special Spear Installation Instructions
Figure 1-1
Single Spear & Dual Spike Assembly
(BS10 & BSE10 Models)
Refer to Figure 1-1& Figure 1-2:
1.
Apply multi-purpose grease all around and along full
inside length of tapered hole in mounting tube (#4).
Refer to Figure 1-2:
2. Insert spear (#3) into spear mounting tube (#4).
Rotate spear so that a flat surface is up and secure
spear with M28 x 1.5 eccentric hex nut (#2).
3. Tighten eccentric nut (#2) to the correct torque. See
“Additional Torque Values”
on page 16.
Apply grease all around full length of tapered hole.
Do not apply grease to chamfered surface of eccentric
nut (#2) or chamfered end of spear mounting tube (#4).
Spear
Chamfer of Eccentric Nut (#2) must face spear
mounting tube (#4) for nut to tighten properly.
Spear Mounting Tube
3
4
2
35147
IMPORTANT:
Do not apply grease to chamfered
surfaces of eccentric hex nut (#2) and chamfered
end of spear mounting tube (#7).
IMPORTANT:
Install eccentric hex nut (#2) with
chamfer facing spear mounting tube (#4).
