10
Section 1: Assembly & Set-up
APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M
10/13/11
Table of Contents
Rear Mud Scraper To Spike Roller
Refer to Figure 1-4:
1.
Lower rear roller to ground level, shut tractor engine
off, and engage parking brake.
2.
Attach left hand scraper mount (#4) to the left side
roller arm (#6) with 1/2"-13 x 1 1/2" GR5 hex head
cap screws (#9), spring lock washer (#15), and two
spacer plates (#7) (Spacer plates to be used on units
with S/N 659515 and above only). Tighten cap
screws (#9) to the correct torque.
3.
Attach spike scrapers (#5) to scraper hanger (#1)
with 3/8"-16 x 1 1/4" GR5 round head square neck
bolts (#10) and hex flange lock nuts (#12). Draw nuts
up snug, do not tighten until after completing
adjustments in Section 3.
NOTE: Do not tighten bolts (#8 & #10) until after
adjustments have been made. See “Mud Scraper
Adjustment (Optional)” on page 14 for instructions.
4.
Attach scraper hanger (#10) to chain guard
mounting bracket (#3) with two 3/8"-16 x 1 1/4" GR5
hex head cap screws (#8), 3/8" flat washers (#13),
and 3/8" lock washers (#14). Secure scraper in place
with hex nuts (#11). Draw nuts up snug, do not
tighten until after adjustments have been made in
Section 3.
5.
Attach opposite end of scraper hanger to scraper
mount (#4) with two 3/8"-16 x 1 1/4" GR5 hex head
cap screws (#8), 3/8" flat washers (#13), 3/8" lock
washers (#4), and hex nuts (#11). Draw nuts up
snug, do not tighten until after completing
adjustments in Section 3.
Rear Mud Scraper Installation to Spike Roller
Figure 1-4
30844
