9
Section 1: Assembly & Set-up
10/13/11
APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M
Table of Contents
Rear Mud Scraper For Packer Roller
Refer to Figure 1-3:
1.
Lower rear roller to ground level, shut tractor engine
off, and engage parking brake.
2.
Attach left hand scraper mount (#4) to the left side
roller arm (#5) with 1/2"-13 x 1 1/2" GR5 hex head
cap screws (#8), spring lock washer (#12), and two
spacer plates (#6) (Spacer plates to be used on units
with S/N 659515 and above only). Tighten cap
screws (#8) to the correct torque.
3.
Attach rear roller scraper (#2) to chain guard
mounting bracket (#3) with two 3/8"-16 x 1 1/4" GR5
hex head cap screws (#7), 3/8" flat washers (#10),
3/8" lock washers (#11), and hex nuts (#9). Draw
nuts up snug, do not tighten until after completing
adjustments in Section 3.
NOTE: Do not tighten bolts (#7) until after
adjustments have been made. See “Mud Scraper
Adjustment (Optional)” on page 14 for instructions.
Rear Mud Scraper Installation to Packer Roller
Figure 1-3
30844
4.
Attach opposite end of rear roller scraper to scraper
mount (#4) with two 3/8"-16 x 1 1/4" GR5 hex head
cap screws (#7), 3/8" flat washers (#10), 3/8" lock
washers (#11), and hex nuts (#9). Draw nuts up
snug, do not tighten until after adjustments have
been made in Section 3.
