Section 1: Assembly & Set-up
AFM3011 All-Flex Grooming Mower 315-783M
3/21/19
19
CAUTION
!
To avoid minor or moderate injury:
1.
Pull back on outer driveline yoke lock collar (#7) and
slide yoke over the tractor’s power take-off shaft.
2.
Release lock collar and continue to push yoke onto
the power take-off shaft until pull collar snaps in
place.
3.
Move driveline back and forth to ensure both ends
are secured. Reattach any end that is loose.
4.
Attach driveline shield chain (#16) to tractor frame.
Hydraulic Hook-up
Figure 1-5
Hydraulic Hook-up
Refer to Figure 1-5:
This mower is equipped and plumbed from the factory
with double acting cylinders, hydraulic hoses, and
couplers for folding the wings and rear deck.
1.
Cut plastic ties securing hydraulic hoses (#9) to hose
support loop (#12). Be careful not to cut plastic tie
securing the ten linchpins (#5).
2.
Route hoses (#9) through hose support loop (#12)
and connect to tractor remote outlets. Quick
disconnect hydraulic fittings for your tractor are
supplied attached to the hoses.
3.
Locate carbon steel wire (#17) attached between
wing cylinders (#16). This wire secures the wing
decks in the folded position during shipment.
Remove and dispose wire.
IMPORTANT:
The driveline must be lubricated
before putting it into service. Refer to
“Lubrication”
on pages 40-45.
72283
Enhance Module Wire Connections For Lights
Figure 1-6
Hook-up Transport Lights
Refer to Figure 1-5:
The lead wiring harness (#10) is equipped with a
round 7-pin male connector for connecting to the tractor’s
7-pin electrical outlet shown in Figure 1-1 on page 15.
1.
Route lead wire harness (#10) through spring hose
loop (#12) as shown.
2.
Connect wire harness (#10) to the tractor’s 7-pin
electrical outlet.
Refer to Figure 1-6:
3.
Check lights to make certain they are operating
correctly.
4.
It is best to have a second person available for this
operation. Start tractor and operate lights as follows:
a. Turn on head lights to verify red lights illuminate.
b. Turn on flasher lights to verify amber light are
blinking on and off.
5.
If lights did not operate properly, recheck hook-up of
wire harness (#1, #2, & #4) to enhance module (#3).
•
Make sure connector (#1D) with a red wire is
connected to the right-hand wire harness (#1).
•
Make sure connector (#2D) with a yellow wire is
connected to the left-hand wire harness (#2).
•
Make sure connector (#3B) on lead wire harness
(#4) is connected to connector (#3A) on enhancer
module (#3).
6.
Check wire harness routing to make sure wires will
not be pinched as the decks are folded and unfolded
and while raising and lowering mower height.
7.
Add cable ties (#13) shown in Figure 1-5 to wire
harness (#1, #2, & #4) and hydraulic hoses (#9) as
needed to secure them in place.
70482
IMPORTANT:
Connectors on wire harness (#1 & #2)
are labeled “Light” on one end and “Enhancer” on
the other end. Ends labeled “Light” connect to the
lights. Ends labeled “Enhancer” connect to enhance
module (#3).
IMPORTANT:
Connector (#1D) has a red wire and
connects to wire harness (#1) on the right side of the
implement. Connector (#2D) has a yellow wire and
connects to wire harness (#2) on the left side of the
implement.
