Land Pride 381-169M, Operator'S Manual

Page: 15 / 32

Section 1: Assembly & Set-up
CB1060 4-In-1 Combination Bucket 381-169M 7/28/22
11
Table of Contents
Refer to Figure 1-2:
1. Check for and remove any debris in the hitch point
areas before hooking-up the bucket.
2. Raise lock pins on loader hitch plate.
3. Drive tractor slowly to the bucket while making sure
the loader hitch plate is parallel with the top angle
bars on the bucket.
4. Rotate top of loader hitch plate slightly forward.
5. Position top of loader hitch plate under the bucket’s
top angle bars. Slowly raise loader arms until the
loader hitch is seated under the top angle bars.
6. Rotate top of loader hitch plate back until face of
loader hitch plate makes full contact with the bucket
hitch plates.
7. Shut tractor down before dismounting. Refer to
“Tractor Shutdown Procedure”
on page 9.
8. Push lock handles on loader hitch plate down. Make
sure lock pins go through bottom slots in the bucket
hitch plate and lock handles are locked down.
9. Continue with
“Hook-Up Hydraulic Hoses”
below.
Hook-Up Hydraulic Hoses
Refer to Figure 1-2:
WARNING
!
To prevent serious injury or death:
•
Hydraulic fluid under high pressure will penetrate the skin
or eyes causing a serious injury. Wear protective gloves and
safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. If an accident occurs, seek
immediate emergency medical care or gangrene may result.
DO NOT DELAY.
•
Shut power machine down and release all hydraulic
pressure to the equipment before connecting or
disconnecting hydraulic hoses to or from the power
machine.
1. Route hydraulic hoses through the most convenient
path to access the tractor or loader power equipment
couplers.
2. Clean quick connect couplers of dirt and connect
quick release couplers to the tractor or loader outlets.
Make sure quick connect couplers have fully
engaged. If they have not, check the following:
a. Make sure couplers are same size and type.
b. Make sure all hydraulic pressure has been
released.
3. Extend and retract hydraulic cylinders with tractor
controls. Switch couplers at the outlets if hydraulic
cylinders operate the opposite direction intended.
IMPORTANT: Make sure coupler fittings on the
hydraulic hoses and power machine are clean
before connecting them together.
NOTE: “Optional Third Function Valve Kits”
can
be purchased for installation on most Kubota B and
L Series tractors with a front mounted loader. See
“Optional Third Function Valve Kits” on page 14.
NOTE:
If Land Pride “
Optional Kits”
are not
included, customer must supply required hydraulic
components to complete the connection between
bucket fittings (#1 & #2) and remote outlets at the
tractor or loader. Refer to
“Customer supplied
Hydraulic System” on page 10.
NOTE: When line (#1) is under pressure, the jaw
will close. When line (#2) is under pressure, the jaw
will open.
Hook-up Bucket
Figure 1-2
Bottom Slots
Bottom Slots
Top Angle Bars
70762