Assembly Instructions
4
Third Function Valve Kit #380-354A Installation Instructions Manual No. 380-353M
7/8/20
Control Lever Assembly
Refer to Figure 3 on page 3 & Figure 4:
1. Remove existing knob (not shown) from end of shift
lever “D”.
2. Install new control handle (#1) onto shift lever (D).
Adjust control handle to align the push buttons to suit
the operator and then tighten set screws (#1A).
Tighten jam nuts (#1B) to lock set screws.
3. Thread control handle wiring harness (#1C) through
hole “E” and forward under the tractor platform.
4. Secure wire harness (#1C) with cable ties (#28)
along shift lever (D) as needed.
Refer to Figure 5:
5.
Reference Connections (#1E):
a. Connect one black wire in wire harness (#1C) to
the black wire in harness (#12A).
b. Connect the other black wire in harness (#1C) to
the white wire in harness (#12A).
6.
Reference Connection (#1D):
a. Connect the two red wires in wire harness (#1C)
to one end of the fused red wire harness (#29).
b. Connect opposite end of wire harness (#29) to the
positive (+) post on the tractor battery.
7.
Secure wire harness (#1C, #29, & #12A) with cable
ties (#28) as needed.
8. Reconnect the disconnected battery cable in step 10
on page 1 to the battery’s negative (-) terminal.
NOTE:
Wire harness (#1C) is attached to control knob (#1).
Wire harness (#12A) is attached to valve (#12).
Wire harness (#29) includes fuse (#30) and attaches
to the tractor battery.
Control Stick Assembly
Figure 4
Bulkhead Mount with Flat Faced Couplers
Figure 5
1
1A 1B
D
E
1C
Push Buttons
74502
28
1C
74503
Attaches to the positive (+)
post on the tractor battery.
